|
Post by shreddagnar on Dec 9, 2019 22:15:53 GMT -5
Does anyone know how much the fan belt should vibrate while running on a Cuyuna? It looks like its shaking around quite a bit in a new rebuild I just got done. I replaced the fan bearings and installed a new belt. The belt felt slightly loose on install. I've looked at another engine and it's the same thing. Should I remove a washer or two on the top to tighten it up a bit or am I worrying about nothing. How tight is too tight? The new belt felt a little thinner than the old take off. I know the fan is important to not burn down, want to get it right. Thanks for any input.
|
|
|
Post by shreddagnar on Dec 15, 2019 10:26:49 GMT -5
|
|