kerry
L2 Scorpion - Above All
Posts: 69
|
Post by kerry on Nov 20, 2016 19:27:48 GMT -5
Hey guys, What is the appropriate clutch puller for a cuyuna 440 factory clutch. Or bolt thread even to do it with water? I have three motors with clutches I have to get off. Thanks Kerry
|
|
crosscut
L2 Scorpion - Above All
Posts: 88
|
Post by crosscut on Nov 20, 2016 21:14:37 GMT -5
You just need a 3/4" shaft, 2 13/16 long......remove the clutch bolt, then remove the clutch retainer nut, inset the shaft and reinstall the retainer nut, I always use an impact gun, it will pop right off
|
|
kerry
L2 Scorpion - Above All
Posts: 69
|
Post by kerry on Nov 20, 2016 22:07:42 GMT -5
Awesome.Thanks for the info!Never thought about using the retainer nut. Kerry
|
|
crosscut
L2 Scorpion - Above All
Posts: 88
|
Post by crosscut on Nov 20, 2016 23:20:46 GMT -5
That is the method listed in the service manual, nice that you don't need a special puller
|
|
cat1978
L1 Scorpion - The Great Snowmobile
Posts: 8
|
Post by cat1978 on Oct 12, 2017 13:09:24 GMT -5
I'm trying the method you are describing above and at 2 13/16 in the shaft isn't long enough for the big nut to push against it. Am I missing something?
|
|
|
Post by stinger440 on Oct 12, 2017 13:35:44 GMT -5
I believe you have to pull off the moveable face first. So you are only pulling the fixed sheave off the crank stub. If you can't get the moveable face off just add a little more to your pusher.
|
|
cat1978
L1 Scorpion - The Great Snowmobile
Posts: 8
|
Post by cat1978 on Oct 12, 2017 14:06:36 GMT -5
Perfect, that was what I was gonna try after work, however was hoping to get my thoughts confirmed. THANKS
|
|