Custom Scorpion Running Board Traction

[mousie]

Here's a great little tool for a great price.Don't miss out for the up coming season.All dies are turned from high strength steel.Works great for adding sure footing to your running boards.Only takes a few seconds to do each hole.Simply drill your 1/2 inch hole, insert the tapered bolt, slide over die and draw the two together.Makes perfect dimple every time.Adds strength and good looks to your vintage running boards.This tool will pay for itself on your first machine. Works on both aluminum and steel running boards.Picture is of a scorpion whip that I just did using the 1/2 die.All dimples done with basic hand tools no impacts needed.
Contact Joe at 715-three eight five-2865 or email me [e-mail]

$25.00 for the 1/2 die plus $4.95 shipping
$99.00 for the set of four 1/2,3/8,5/16,1/4 plus $5.95 shipping

Attachments:

[mousie]

Here is a picture of the full 4 piece kit.Most guys use the 1/2 die for running boards.Others use the 3/8 die for after market skis for installing counter sinks for wear bar.

Attachments:

[mousie]

Now offering a 1" die